![]() Following projects like the Solar Impulse and NASAs Helios wing, the idea of. Upgrade, evolve and hack the victory with your special. Solarcopter: Worlds First Solar-Powered Helicopter Takes Off on First Flight. I’m afraid while i’m at near full throttle (lets say 120%) the pixhawk will not even try to manipulate the motors to stabilise the copter in the 20% remaining throttle limit. Cool online IO game - Fly a copter, keep shooting for total destruction in epic and intense battles. ![]() The only thing i am worried about is that to stabilize the drone, the pixhawk will not go over the 100% throttle limit. The only thing i can do is to go over 1000 th_max, right now it’s at 1400 which brings the total amp’s to around 25 amps while full throttle. The ESC are calibrated correctly, radio calibration is done. The theft suspect is accused of trying to start four helicopters at. This is really annoying because while i’m dropping fast, it takes way to long to stop the drop. The FBI is investigating after a helicopter crashed at an airport in California on Wednesday during a reported attempted theft. I hooked up a servo tester to one of the motor’s, it pulled 9 amp’s on it’s own, so the pixhawk isn’t even nearly using 50% of the total throttle it could use. So i hooked up an amp meter, full throttle was ± 14 amp’s, while each motor i use is rated 15 amps (with 20 esc onboard). I noticed that maximum throttle was not nearly as ‘hard’ as it was on the kk board. I Build a quadcopter using a cheap KK board, which was barely flyable, so i moved on to a pixhawk. ![]() Im pretty new to copters in general, i tried reading a lot about my problem but i couldn’t figure it out.
0 Comments
Leave a Reply. |